WIFI-CON. User Manual. Part Number: Important: Read all instructions prior to installation. ... Test Motion Sensor by walking around desired detection...
Important: Read all instructions prior to installation.
20 Watt Motion Activated Security Light Features • Two 10 Watt Light Heads • Motion and Light Sensor • High heat conduction aluminum alloy shell with optimal heat dissipation • Anti-corrosion and a weatherproof design
Specifications Operating Voltage Rated Wattage Intensity Color Temperature Beam Angle CRI LED Type LED Count and Watts IP Rating Operating Temperature Range Warranty
Crossbar Screws Junction Box
90~135 VAC 20 Watts 1640 lumen 4000 K 100 degree / light head 84 COB 2 LEDs x 10 Watts Weatherproof IP65 -40~122° F (-40~50° C) 5 Years
Center Screw Hole Mounting Screw
Gasket
1.
Mounting Screw Cover
Rubber Washer
Crossbar
Installation Begin by turning off power to the circuit from the electrical panel. 2. Remove existing fixture if retrofitting. 3. Install Crossbar to J-Box using screws provided with J-Box and tighten. 4. Insert wiring from light through center hole in Foam Gasket. 5. Connect the yellow/green (ground) wire from light to grounding screw inside J-Box. Connect the white (neutral) wire from the supply cable to the white wire of light and secure with a wire nut. Connect the black (line) wire from the supply cable to the black wire of light and secure with a wire nut. 6. Insert wiring into J-Box in a manner that allows a clear path for the Mounting Screw to pass unobstructed to Crossbar. 7. Align Foam Gasket and Light to J-Box and Crossbar, removing the appropriate knockouts on Foam Gasket. Be sure to mount the Light so the Motion Sensor is at the bottom. 8. Apply light coat of silicone caulk to outer edge of Foam Gasket sealing the Light to J-Box. Leave a slight gap in the silicone at the bottom of the mounting flange. 9. While keeping the Foam Gasket and Light aligned to J-Box, insert and tighten Mounting Screw. 10. Install Mounting Screw Cover by pressing onto head of Mounting Screw. 11. Restore power to the circuit from the electrical panel. 12. Loosen adjustment knobs and aim Light Heads to desired position then tighten adjustment knobs. Glare shields may also be rotated for blocking undesired light output.
White Wire Supply Mount Base
Green or Bare Black Wire Ground Wire Supply Wire Nut
Setting the Motion Sensor Detection Range PLEASE READ THESE INSTRUCTIONS CAREFULLY
Adjustment Knob
AND SAVE THEM, YOU MAY NEED THEM AT A LATER
On-Time Adjustment Switch
NSTALLING YOUR MOTION ACTIVATED
Photocell
LIGHT, YOU ARE READY TO SET/AIM THE MOTION
SENSOR. MAKE SURE THE WALL SWITHCH IS IN THE
Switch the TIMES/TEST switch in the TEST position to disable the photocell and allow light to come on during daylight
Rotate the RANGE knob fully clockwise to maximum
Adjusting Sensor 1. 2. 3. 4.
5. 6.
Set ON-TIME switch to TEST position. Rotate RANGE knob clockwise to the MAX(maximum) position. Aim the Motion Sensor at least 10 degrees downward and across the desired detection area. Test Motion Sensor by walking around desired detection area. Light will turn on for approximately 40 seconds and then turn off if no additional motion is detected within 8 seconds. Red LED on Motion Sensor will turn on then off when motion is detected. Aim sensor and adjust RANGE until desired detection area is covered. Change ON-TIME switch to the desired setting (1/5/10 minutes)
Manual Override Turn the wall switch off and back on within 3 seconds to disable the Motion Sensor and allow the light to run continuously all night. Light will automatically turn off at dawn and reset to motion detection for the next dusk cycle.